Suzuki AN650 2002 Service Manual page 132

4-6 DRIVE TRAIN
• Remove the final driven gear bearing by using the appropriate
bar.
• Remove the final drive gear bearing with the special tools.
09941-64511: Bearing remover
09930-30104: Sliding shaft
• Install the bearings to the final gear case with the special tool.
09913-70210: Bearing installer set
Replace the removed bearing with a new one.
• Install the plate 2 into the final gear case cover at the No.2
gear, and then install the bearing.
Install the plate 2 with the convexity A showed up.
FINAL DRIVEN GEAR HUB
Inspect the final driven gear hub for wear and damage. If any
defects are found, replace the final driven gear hub with a new
one.