Suzuki AN650 2002 Service Manual page 382

First check the insulation between A and B terminals with the
tester. Then apply 12 V to terminals as shown and check the
continuity between A and B. If there is no continuity, replace
the side-stand relay with a new one.
STARTER RELAY DIODE INSPECTION
• Remove left frame cover. (
• Remove the diode.
Measure the voltage between the terminals using the multi cir-
cuit tester.
A
B
✽ More than 1.4 V (tester's battery voltage)
09900-25008: Multi circuit tester set
Tester knob indication: Diode test (
NOTE:
If the tester reads under 1.4 V when the tester probes are not
connected, replace the batter of multi circuit tester.
9-16)
+ Probe of tester to:
A
✽
)
Unit: V
B
0.3 – 0.6
ELECTRICAL SYSTEM 10-17