Assembly - Freemotion F 5.8 User Manual

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove
the packing materials. Do not dispose of the
packing materials until you complete all
assembly steps.
• To identify small parts, see page 6.
1. IMPORTANT: Do not remove the foam block
(not shown) located under the pedals until
you have completed step 2.
Identify the Shield Cap (5) and the Upright (26)
and orient them as shown. Slide the Shield Cap
upward around the Upright.
While another person holds the Upright (26)
near the Frame (1), locate the wire ties in the
Upright.
See the inset drawing. Tie the lower end of a
wire tie to the ends of the Wire Harness (77)
and the Coaxial Cable (136). Pull the other end
of the wire tie upward out of the top of the
Upright (26).
Next, tie the lower end of the other wire tie to
the ends of the Power Cable (81) and the
Audio/Video Cable (135). Pull the other end of
the wire tie upward out of the top of the Upright
(26).
Then, untie and discard the wire ties.
• In addition to the included tool(s), assembly
requires the following tool(s):
one Phillips screwdriver
Assembly may be easier if you have a socket set
or a set of ratchet wrenches. To avoid damaging
parts, do not use power tools.
1
Wire
Ties
5
77
136
7
81
135
81
26
1
Wire
Ties
77
136
135