Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• If a part is not in the hardware kit, check to see if
it has been preassembled.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 5.
1. Tip: Avoid pinching the wires inside the
Upright (2).
Raise the Upright (2) to the position shown.
Secure the Upright to the Frame (1) with
four M10 x 20mm Screws (111) and four
M10 x 16mm Washers (123); start all the
Screws, and then tighten them.
• The following tools (not included) are required for
assembly:
one adjustable wrench
one Phillips screwdriver
a set of metric hex keys
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
6
111
123
2
1
Advertisement
Table of Contents
