Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Because of its weight and size, assemble the
strength equipment in the location where it will be
used. Make sure that there is enough clearance
around the strength equipment.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, see page 6.
1. Remove all parts (24, 29, 31, and 32) from the
Connecting Frame (38).
Identify the Long Cable (40) and the Short
Cable (not shown). Orient the Long Cable as
shown, and insert it through the Connecting
Frame (38).
Reattach the Large Pulley (24) to the
Connecting Frame (38) with the M10 x 50mm
Socket Bolt (29), the two M10 Washers (31),
and the M10 Locknut (32). Make sure that the
Long Cable (40) is between the Large Pulley
and the indicated rod.
2. Remove the M10 Locknut (32), the two M10
Washers (31), the M10 x 135mm Socket Bolt
(78), and the Large Pulley (24) from the Main
Frame (68).
Orient the Connecting Frame (38) as shown,
and set it on the indicated side of the Main
Frame (68).
Route the Long Cable (40) through the Main
Frame (68) as shown.
Reattach the Large Pulley (24) to the Main
Frame (68) with the M10 x 135mm Socket Bolt
(78), the two M10 Washers (31), and the M10
Locknut (32). Make sure that the Long Cable
(40) is below the Large Pulley.
• The following tools (not included) are required for
assembly:
one adjustable wrench
one Phillips screwdriver
a set of metric hex keys
snap ring pliers
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
40
Large
End
2
78
38
7
29
38
31
24
Small
31
Rod
End
32
24
31
68
31
40
32
Advertisement
Table of Contents
