Table of Contents
Advertisement
ASSEMBLY
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. Most people find that by
setting aside plenty of time, assembly will go
smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
1.
Before beginning assembly, make sure that
you understand the information in the box
above. Important: Some of the parts
described in the assembly steps may be
preassembled.
Remove the four packing bolts and locknuts (not
shown) from the indicated locations at the base of
the Frame (1) and the pallet (not shown). Discard
the packing bolts, locknuts, and pallet.
Attach a Stabilizer (3) to the base of the Frame
(1) with four M10 x 84mm Button Head Screws
(58), four M10 Washers (55), and four M10 Nylon
Locknuts (63) as shown.
Attach the other Stabilizer (3) to the other side
of the Frame (1) in the same manner.
If the floor beneath the weight system is
uneven, level the weight system by placing
Foot Spacers (83) between one or more of the
Rubber Feet (50) and the Stabilizers (3) (see
the inset drawing).
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
Assembly requires the included hex keys
the following tools (not included):
• Two adjustable wrenches
• One standard screwdriver
• One Phillips screwdriver
• Lubricant (three grease packets are included)
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
58
55
55
3
Packing Bolts
and Locknuts
63
83
3
50
51
5
and
Packing Bolts
and Locknuts
1
55
58
63
55
3
Advertisement
Table of Contents
