Care And Maintenance; Battery Maintenance - Power Fist 9049057 Instructions Manual

V1.0
4. Press the pivoting shoe assembly against the surface to be cut. Align
the saw blade along the direction of the cut. Slowly tilt the saw
forward to lower the blade into the workpiece.
WARNING! Do not bend or twist the blade or attempt to cut with the tip as it
may cause kickback and blade damage.
IMPORTANT! Use a fine blade or cut at a higher speed if chattering or
vibration occurs. Replace the blade if the saw overheats or clogs.
5. After completing the cut, release the trigger.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Only use accessories intended for use with this tool.
4. Keep the tool handles or gripping surfaces clean and dry.
5. Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
6. Clear the vents of any dirt, dust and debris on a regular basis to
prevent the tool from overheating.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.

BATTERY MAINTENANCE

Avoid the risk of battery short circuits during transport, storage or disposal
by isolating both terminals with adhesive tape or pack the battery in a
plastic bag or a cardboard box.
1. The longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 50 to
86°F (10 to 30°C). Do not charge the battery when the temperature is
below 32°F (0°C) or above 104°F (40°C). This is important and will
prevent damage to the battery pack.
2. Charge the battery at rates recommended by the manufacturer.
Visit www.princessauto.com for more information
20V Li-ion Cordless Reciprocating Saw 9049057
13