Table of Contents
Advertisement
Available languages
Available languages
8843518
SAW BLADE INSTALLATION
1.
Loosen the screw (Fig. 2-1) holding the
chuck cover (Fig 2-2) to the reciprocating
saw housing (Fig. 2-3).
2.
Lift up the chuck cover.
3.
Loosen one of the set screws (Fig. 3-2) on
the blade chuck (Fig. 3-5) with the 4 mm
hex key wrench (Fig. 3-3).
4.
Install a new blade (Fig 3-4). Make sure the
blade is properly seated in the blade chuck.
5.
Tighten the set screw on the blade chuck,
loosened in step 3, using the hex key
wrench. Make sure the blade is secure and
centered in the blade guard (Fig. 1-1)
6.
Fasten the screw (Fig. 2-1) to fix the chuck
cover (Fig. 2-2) to the reciprocating saw
housing (Fig. 2-3).
OPERATION
1.
Draw a guide line for cutting (if possible) on the workpiece.
2.
Press the safety latch on the throttle lever (#13) forward while pressing
the throttle lever (#13) to begin operating the reciprocating saw. Allow the
saw to reach full speed before placing the blade onto the workpiece.
3.
Cut your line. Let the reciprocating saw do the work. Do not place
unnecessary pressure on the reciprocating saw. Excessive pressure may
break the blade or stall the reciprocating saw, potentially causing damage
to the workpiece or personal injury.
4.
When you have finished cutting your line, pull the reciprocating saw from the
workpiece and release the throttle lever (#13) to stop the reciprocating saw.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool fittings, alignment, hoses and power supply cord periodically.
Have damaged or worn components repaired or replaced by an authorized
technician. Only use identical replacement parts when servicing.
10
Air Reciprocating Saw
For technical questions call 1-800-665-8685
V1.0
Fig. 2
Fig. 3
Advertisement
Table of Contents
