Maintenance - Power Fist SKX355D-120 User Manual

V4.0
Hold the tool firmly with both hands.
First keep the wheel without making
any contact with a work piece to be
cut. Then turn the tool on and wait
until the wheel attains full speed.
The cut is made by pulling the tool
toward you (not by pushing away
from you). Align the notch on the
base with your cutting line when
performing a cut.
Switch off the tool on the position posed when finishing a cut. Raise the tool
after the wheel comes to a complete stop.

MAINTENANCE

CAUTION:
•
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
•
Never use gasoline, benzine, thinner, alcohol or the like. Discoloration,
deformation or cracks may result.
DRESSING DIAMOND WHEEL
If the cutting action of the diamond wheel begins to diminish, use an old
discarded coarse grit bench grinder wheel or concrete block to dress the
diamond wheel. To do this, tightly secure the bench grinder wheel or concrete
block and cut in it.
Visit www.princessauto.com for more information
14 in. Electric Wet/Dry Concrete Saw 8957102
17