Table of Contents
Advertisement
Available languages
Available languages
V1.0
2.
Check the cutting accessory for damage before each use. A damaged
accessory can break during use and cause serious injury.
3
Inspect material for foreign objects such as staples, nails or debris.
Remove from material before cutting.
4.
Affix the workpiece to a stable platform to prevent movement, minimize
body exposure to injury, cutting accessory binding or loss of control.
5.
Position the tool on the larger section of a supported workpiece to
complete a cut. Cut the small portion away from the larger portion.
Support the smaller portion if possible to prevent it from binding when
the cut is almost complete.
6.
Never confine the part of the workpiece being cut away by holding,
clamping or using length stops against it. That part of the workpiece
could become wedged against the blade and be thrown violently. The
cut away part of the workpiece must be free to move sideways
RECIPROCATING SAW PRECAUTIONS
DANGER! When the tool is in operation, keep hands away from the saw
blade and the area it is being applied to. Failure to follow this warning will
result in amputation, serious personal injury or death.
1.
Always make sure the reciprocating saw is clean before using.
2.
Always handle the reciprocating saw blade with care when mounting
or removing it.
3.
Always be aware of the position of your hands relative to the blade.
Avoid awkward hand positions where a sudden slip could cause a hand
to move into the blade.
4.
Never reach behind or beneath the blade.
KICKBACK PRECAUTIONS
Kickback is a sudden reaction to a pinched or snagged cutting accessory.
The tool kicks out and away from the workpiece while the cutting accessory
is still active. This can inflict a serious injury on the user or a bystander.
Kickback can also damage the tool or workpiece.
Kickback can be avoided by taking proper precautions:
1.
Maintain a firm grip on the tool and position your body and arms to
allow you to resist a kickback. Kickback will propel the tool in the
direction opposite to the cutting accessory' s teeth or direction of
rotation. A snagged rotary cutting bit may pull the tool out of the grasp
of the user.
Visit www.princessauto.com for more information
20V Li-ion Cordless Reciprocating Saw
9049057
9
Advertisement
Table of Contents
