Start-Up Of The Machine; Attachment, Mounted Model; Attachment, Trailed Model - HE-VA Disc-Roller Classic Operating Instructions Manual

General Information
The machine is supplied as standard in transport position. At start-up, attach the machine to the
tractor.
Check that the towing hook height is between 400 and 500 mm.
Important:
Check that the male quick-couplings of the Disc-Roller fit the
female quick-couplings of the tractor.
The machine requires two double-acting outlets (mounted) or three double-acting outlets
(trailed).
The hoses for the drawbar - / wheel cylinder are provided with red cable straps.
The hoses for the folding cylinder are provided with blue cable straps.
The hoses for the disc cylinder are provided with green cable straps.

Attachment, Mounted Model

1. Reverse the tractor to the machine and attach.
2. Connect all hydraulic hoses to the tractor outlets.
3. Lift the machine to maximum transport height.
4. Fold up the side sections (blue) towards the stop on the centre frame.
5. When the side sections are unfolded, open the locking claws first and after that
the side sections will unfold.
6. When the side sections are completely unfolded, let go of the hydraulic handle
and the machine is ready for use.
7. Unfold the edge equipment to working position.
8. Now lift and lower the discs to the required working depth.

Attachment, Trailed Model

1. Reverse the tractor to the machine.
2. Connect all hydraulic hoses to the tractor outlets.
3. Pressurise the drawbar - and the wheel cylinder (red) so that the machine
drawbar is lifted to the suitable height.
4. Then reverse the tractor and attach the machine.
5. Now lift the machine to maximum height and tilt the depth stop backwards
towards the drawbar cylinder.
6. Fold up the side sections (blue) towards the stop on the centre frame.
7. When the side sections are unfolded, open the locking claws first and after that
the side sections will unfold.
8. When the side sections are completely unfolded, let go of the hydraulic handle
and the machine is ready for use.
9. Unfold the edge equipment to working position.
10. Now lift and lower the discs to the required working depth.
Disc-Roller 4,0 – 5,0 m (2-section)

Start-up of the machine

9
16-08-2022