Table of Contents
Advertisement
Transport position to workposition
1. Important: When unfolding the side sections, the locking claw must first
be relieved by activating the folding function, until the side sections meet
the stop at the center frame. Next, when the unfolding function is activated,
the locking claw then first will open, after which the side sections are
unfolding.
2. When the side sections are completely unfolded, let go of the hydraulic handle
and the machine is ready for use.
Always set the tractor's flow control on MAX, to make sure that the side
sections will follow each other.
3. Unfold the edge equipment to working position.
4. Now lift and lower the discs to the required working depth.
Transport
1. Lift the discs to the top before folding up the machine.
2. Then lift the machine to maximum transport height.
3. Now pressurise the folding cylinders and the side sections will be folded up.
After that put the function in floating position, however, ensure that the
locking claws have locked the side sections.
4. Now the machine is secured and ready for transport.
5. Lower the machine in order to minimise the transport height, to obtain a center
of gravity as low as possible. It is recommendable to drive slowly and
carefully in turns and roundabouts.
Uncoupling, Mounted Model
1. Put down the machine on firm ground and relieve all hydraulic hoses.
2. Now the machine may be uncoupled.
Uncoupling, Trailed Model
1. Lift the machine up and tilt the depth stop on the drawbar forward towards
2. Now lower the machine onto firm ground.
3. Adjust the drawbar – and wheel cylinder (red) so that the drawing bolt is
4. Now the machine may be uncoupled.
5. Drive the tractor a little forward and then relieve all hydraulic hoses.
Important:
Disc-Roller 4,0 – 5,0 m (2-section)
the tractor.
loose.
Put the machine on level ground
and relieve the hydraulics, before
leaving the machine.
10
16-08-2022
Advertisement
Table of Contents
