Labomed Pixel Pro 3.2 User Manual page 45

R
PixelPro 3.2 Instruction Manual
click. Double left-click completes the drawing.
Polyline: Left click adds new line segments to the existing polyline. Double left-click
completes the drawing .
Rectangle: Draws an orthographic rectangle. The length, width, perimeter and area of
the rectangle can be measured.
Polygon: Left-click multiple times to set the number of sides of a regular polygon. Double
left-click sets the size of the polygon and completes the drawing.
Ellipse: Draws an orthographic ellipse, similar to drawing a rectangle. The perimeter,
area, major axis, minor axis, and eccentricity of the ellipse can be measured.
Roundness: Calculates the roundness of a circle based on two line segments with
endpoints on the circumference of a measured circle. Both line segments should pass
through the same center. The true roundness value of the circumference of the circle is
obtained. The value is equal to one-half of the difference between the two line segments.
Radius Circle: Draws a circle by selecting the position of its center and any point on its
circumference. Left click completes the drawing.
Diameter Circle: Draws a circle by selecting the two endpoints of its diameter. Left click
completes the drawing.
3-Point Circle: Draws a circle by selecting any three points on its circumference. Left click
completes the drawing.
Concentric Circles: Draws a circle by its radius. Click to set the radius of a second circle
concentric to the first. Double click completes the drawing.
4-Point Double Circle: The first click positions the center of the first circle; the second
click defines the radius length of the first circle. The third click positions the center of the
second circle; the fourth click defines the radius length of the second circle.
6-Point Double Circle: Click three times to select three points on the first circle, then
click another three times to select the three points of the second circle and complete
the drawing.
Arc: Draw a curved line by selecting three points on the arc. The third click completes
the drawing.
3-Point Angle: Measures the angle between two connected lines. Click to draw the
endpoint and intersection point of the two lines. The third click completes the drawing.
4-Point Angle: Measures the angle between two unconnected lines. Click to draw the
endpoints of the two lines. The fourth click completes the drawing.
Dot: Dot marking or dot counting. Manually counts or marks the quantity of targets. Also
records the XY coordinate value of the point.
44