Temperature Control (Only For Cooling Camera) - Labomed Pixel Pro 3.2 User Manual

PixelPro 3.2 Instruction Manual
Gamma: Adjusts the median of color levels. Setting ranges from 0.64 to 2.55.
Histogram display: Histogram supports linear or logarithmic mode.
Default: Click the [Default] button to restore the module's parameters to factory defaults.
Color level adjusting defaults to manual, and the default gamma value is 2.10.
Notes:
1) Calculating and displaying the histogram curve takes up some system resources, due
to running data statistics in real time. When this module is applied, camera frame
rate may drop slightly. Once the module finishes working, data statistics calculation
resources are freed up and the camera rate can reach its maximum again.
2) After canceling automatic color level adjusting, level values will be set to defaults (0
and max).
3.9

Temperature Control (only for Cooling camera)

The software supports temperature adjustments by cooling cameras; noise reduction
can be achieved by reducing the working temperature of the picture sensor .
Current: Displays the current camera temperature.
Refrigeration: Three options – normal temperature, 0°, and low temperature – are
available.
Fan Speed: Controls the fan speed. Monochrome Cooling camera supports three speeds:
High (default), Medium and Low. Color Cooling camera supports six speeds; default is 3.
Low speeds can reduce noise, but heat dissipation is slightly less effective.
Default: Resets current parameters to factory defaults. "Low temperature" refrigeration
is default.
Note: If the camera (Monochrome Cooling camera only) supports the high temperature
warning function and the external environment temperature is too high, the program
will display the following temperature warning prompt message and the indicator light
on the camera will begin flashing red.
17
R