Delay Capture - Labomed Pixel Pro 3.2 User Manual

R
PixelPro 3.2 Instruction Manual
Save to RAM: Image data is temporarily saved in RAM; then, after image capturing is
complete, all the image data is transferred to the hard drive. Select Save to RAM and
enable RAM to save images. The maximum number of images that can be saved in RAM
will be shown. This saving mode allows the camera to maintain a high transmission speed
of the images when capturing and avoids data loss due to low transmission speed. This
saving mode is limited by the volume of the computer's RAM, so it is not suitable for
long-duration or high-quantity volumes of image capturing.
Default: Click the [Default] button to restore the module's parameters to factory defaults.
The default saving mode is compressed mode with full resolution frame, with the total
number of frames at 10 frames, and the total default capturing time at 10 seconds.
Image data is saved by default to the local hard drive.

3.17 Delay Capture

Total Time: Captures images for the duration selected. Default is 1s. Setting ranges from
1 to 9999 seconds.
Total Frame: Captures the specified quantity of frames . Default is 10 frames. Setting
ranges from 1 to 9999 frames.
Playback Rate: Records according to the specified playback frame rate. Default is 25.
Setting ranges from 1 to 10000 frames.
Interval Time: Interval time for capturing images in one of three time unit options:
minutes, seconds, and milliseconds. Default is 0 minutes. Setting ranges from 0ms to
120min.
Delay time: Introduces a delay before capturing images in one of three time unit options:
minutes, seconds and milliseconds. Default is 0 minutes. Setting ranges from 0ms to
120min.
Video Format: AVI, MP4, and WAM are supported. Default format is AVI.
25