Trigger (Only For Monochrome Cooling Camera) - Labomed Pixel Pro 3.2 User Manual

R
PixelPro 3.2 Instruction Manual
Capture Frame: Begins capturing images according to the parameters set and saves each
frame as an individual image. Click [Stop] to terminate the capturing task early.
Capture as Video: Begins capturing images according to the parameters set
and convert them into a video directly. Click [Stop] to terminate the capturing task
early.
MPTIF: When a Dhyana 400DC is connected, it supports saving images in MPTIF format.
If both TIF and MPTIF formats are selected, only MPTIF format images will be generated.
Note:
There is a quantitative relationship between total time, total number of frames, and
playback frame rate. The final value of total time = total number of frames/playback
frame rate is rounded down.

3.18 Trigger (only for Monochrome Cooling camera)

There are two output modes for image output: frame mode and stream mode.
Frame mode: Waits for an external trigger before outputting single images. Hardware
trigger mode and software trigger mode are available.
Flow mode: Captures a continuous real-time preview of images without requiring a
trigger and embeds image data in the stream .
Hardware Off: Indicates that the hardware trigger mode is off at this time, and the
camera is always taking pictures.
Hardware On: Turns on the hardware trigger and enters standard trigger mode. The
camera will wait for a trigger and no picture taking will be carried out. The camera will
take pictures only when a trigger signal is received.
26