Table of Contents
Advertisement
4 Configuration
It also offers an overall status of common software features:
STP: Click Settings to link to Configuration > Spanning Tree > STP Bridge Global Settings. Default is
disabled.
Port Mirroring: Click Settings to link to Configuration > Port Mirroring. Default is disabled.
IGMP Snooping: Click Settings to link to Configuration > IGMP Snooping > IGMP Snooping. Default is
disabled.
DHCP Client: Click Settings to link to System > System Settings. Default is disabled.
Power Saving: Click Settings to link to System > Power Saving. Default is enabled.
SNMP Status: Click Settings to link to System > SNMP Settings > SNMP Global State. Default is enabled.
802.1X Status: Click Settings to link to Security > 802.1X > 802.1X Settings. Default is disabled.
Safeguard Engine: Click Settings to link to Security > Safeguard Engine. Default is enabled.
Jumbo Frame: Click Settings to link to Configuration > Jumbo Frame. Default is disabled.
System > System Settings
The System Setting allows the user to configure the IP address and the basic system information of the
Switch.
IP Information: There are two ways for the switch to obtain an IP address: Static and DHCP (Dynamic Host
Configuration Protocol).
When using static mode, the IP Address, Subnet Mask, Gateway and DHCP Option 12 State can be
manually configured. When using DHCP mode, the Switch will first look for a DHCP server to provide it with
an IP address (including network mask and default gateway) before using the default or previously entered
settings. By default the IP setting is static mode with IP address is 10.90.90.90 and subnet mask is 255.0.0.0.
System Information: By entering a System Name and System Location, the device can more easily be
recognized.
Login Timeout: The Login Timeout controls the idle time-out period for security purposes, and when there is
no action for a specific time span in the Web-based Management. If the current session times out (expires),
the user is required a re-login before using the Web-based Management again. Selective range is from 3 to
30 minutes, and the default setting is 5 minutes.
DES-1210/ME Series Metro Ethernet Managed Switch User Manual
Figure 4.12 – Device Information
1
1
7
7
Advertisement
Table of Contents
