Reading Configuration Menu; Figure 3.3 Flow Chart For Reading Configuration Menu - Newport i Series Operator's Manual

3.2.4 Reading Configuration
is required that you put the controller in the Standby Mode for any
It
configuration change other than Set Points & Alarms.

Figure 3.3 Flow Chart for Reading Configuration Menu

ENTER READING CONFIGURATION MENU:
Press a
Press d
Press d
SENSOR SUBMENU:
Press d
TEMPERATURE UNIT SUBMENU:
Press d
Press b
Press d
FILTER CONSTANT SUBMENU:
Press d
Press b
Press d
1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to RDG Reading Configuration Menu.
3) Display advances to SNSR Sensor.
4) Sensor selection for Autotune, Loop, or Ramp and Soak °F.°C
is for temperature and DRRh is for Humidity.
5) Display flashes previous Temperature Unit selection.
6) Scroll though the available selections to the Temperature Unit
of your choice: °F or °C .
7) Display shows STRD stored message momentarily and then
advances to FLTR Filter Constant.
8) Display flashes previous selection for Filter Constant.
9) Scroll though the available selections:
0001 , 0002 , 0004 , 0008 , 0016 , 0032 , 0064 , 0128
10) Display shows STRD stored message momentarily only, if
change was made, otherwise press a to advance to the next
menu.
The Filter Constant Submenu allows the user to specify the
number of readings stored in the Digital Averaging Filter.
For PID control select filter value 0001-0004. A filter value of 2 is
approximately equal to 1 second RC low pass time constant.
16