Setpoints; Configuration Menu; Figure 3.2 Flow Chart For Configuration Menu - Newport i Series Operator's Manual

3.2.2 Set Points
SETPOINT 1:
Press a
Press d
Press b & c 3) Press b and c to increase or decrease Setpoint 1
Holding b & c buttons down for approximately 3 seconds will speed up the
rate at which the Setpoint value increments or decrements.
Press b & c 4) Continue to use b and c to enter your 4-digit Setpoint 1 value.
Press d
SETPOINT 2:
Press d
Press b & c 7) Press b and c to increase or decrease Setpoint 2
Holding b & c buttons down for approximately 3 seconds will speed up
the rate at which the setpoint value increments or decrements.
Press d

3.2.3 Configuration Menu

Figure 3.2 Flow Chart for Configuration Menu

1) Press a, if necessary until SP1 prompt appears.
2) Display shows previous value of "Setpoint 1".
respectively.
5) Display shows STRD stored message momentarily and then
advances to SP2 only, if a change was made, otherwise press
a to advance to SP2 Setpoint 2 Menu.
6) Display shows previous value of "Setpoint 2".
respectively.
8) Display shows STRD stored message momentarily and then
advances to CNFG only, if a change was made, otherwise press
a to advance to CNFG Configuration Menu.
15