Alarm 1 Menu; Figure 3.4 Flow Chart For Alarm 1 - Newport i Series Operator's Manual

Temperature & humidity controller

Hide thumbs Also See for i Series:

Table of Contents

3.2.5 Alarm 1

This unit is equipped with two physical outputs that can only be configured as

follows: Alarm 1 & Alarm 2, Alarm 1 & Output 2, Output 1 & Alarm 2, Output 1

& Output 2, Analog Out 1 & Alarm 2, Analog Out 1 & Output 2. Analog Out

available only if Analog Output Option board is factory installed. Alarm1 will only

work for Humidity, not Temperature.

If Analog Output Option is

installed, the controller will skip

Alarm 1 Menu item to Analog

Output.

Alarm must be DISABLED if

Ramp is ENABLED.

ENTER ALARM 1 MENU:

Press a

Press d

Press a

Press d

1) Press a, if necessary, until CNFG prompt appears.

2) Display advances to RDG Reading Configuration Menu.

3) Press a, until Display advances to ALR1 Alarm 1 Menu.

4) Display advances to Alarm 1 ENBL Enable or DSBL Disable

Submenu and flashes the previous selection.

Alarm 1 is designed to

monitor the humidity value

around Setpoint 1 and Alarm

2 is designed to monitor the

temperature value around

Setpoint 2.

Table of Contents