Analog Output (Retransmission) Menu; Figure 3.5 Flow Chart For Analog Output (Retransmission) - Newport i Series Operator's Manual

3.2.6 Analog Output (Retransmission)
Analog Output works only for Humidity Readings and can be configured
as Retransmission or Control outputs. This section will explain
Retransmission Output.
This unit is equipped with two physical outputs that can only be configured as
follows: Alarm 1 & Alarm 2, Alarm 1 & Output 2, Output 1 & Alarm 2, Output
1 & Output 2, Analog Out 1 & Alarm 2, Analog Out 1 & Output 2. Analog
Output is available only if Analog Output Option board is factory installed.
If Analog Output Option is not installed, the instrument will skip to Alarm 2 Menu.

Figure 3.5 Flow Chart for Analog Output (Retransmission)

ENTER ANALOG OUTPUT MENU:
Press a
Press d
Press a
Press d
1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to RDG Reading Configuration Menu.
3) Press a , if necessary, until Display advances to ANLG
Analog Output Menu.
4) Display advances to Analog Output ENBL Enable or DSBL
Disable Submenu and flashes the previous selection.
21