Siemens SIMATIC Ident Function Manual page 88

Configuring the instructions
4.6 Programming the Ident profile
Byte Value
Bytes
No. of
13...14 transpond-
ers
Byte 15 field_on_
control
Byte 16 field_on_
time
88
RFID sys- Meaning
tem
RF300 To be assigned the value "0x0001".
RF200, To be assigned the value "0x00".
RF300
RF200 Transponder type
0x01 Any ISO transponder
RF300 Selection of the transponder types used
With the value "0x01"/"0x31" (ISO 15693 general), the readers of the 2nd gen-
eration always use the ISO commands with which the highest performance can
be achieved for the particular transponder. With readers of the 1st generation,
the value "0x01" activates the general ISO mode with rudimentary ISO com-
mands. With this setting, the performance is generally limited, but operation is
basically guaranteed with every ISO-compatible transponder.
All ISO 15693 transponders (MDS D) specified in the system manual "SIMATIC
RF300" support these ISO commands.
The following values can be set:
Value Transponder
type
0x00 RF300
(RF3xxT)
0x01 ISO 15693
general
0x03 ISO 15693
(MDS D3xx;
Infineon)
0x04 ISO 15693
(MDS D4xx,
Fujitsu - 2 KB)
0x05 ISO 15693
(MDS D1xx,
NXP)
0x06 ISO 15693
(MDS D2xx,
TI)
0x07 ISO 15693
(MDS D261,
STM)
0x08 ISO 15693
1)
(MDS D5xx,
Fujitsu - 8 kB)
0x10 RF300
1)
(RF3xxT)
0x20 ISO 14443
1)
(MIFARE
Classic MOBY
E, E6xx)
Description
For all transponders of the type "RF3xxT"
Any ISO transponder
Activation of the general ISO mode with rudimentary
ISO commands. With this setting, operation is basi-
cally guaranteed with every ISO-compatible tran-
sponder.
e.g. MDS D324, D339
e.g. MDS D421, D422, D423, D424, D425, D426,
D428, D460
e.g. MDS D100, D124, D126, D139, D150, D165
e.g. MDS D200
e.g. MDS D261
e.g. MDS D521, D522, D524, D525, D528
For all transponders of the type "RF3xxT"
e.g. MDS E600, E611, E623, E624
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04