Siemens SIMATIC Ident Function Manual page 73

Command Command code
HEX
PUT 0x65
WRITE-ID 0x67
KILL-TAG 0x6A
LOCK-TAG-BANK 0x79
EDIT-BLACKLIST 0x7A
GET-BLACKLIST 0x6C
READ-CONFIG 0x61
WRITE-CONFIG 0x78
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
Parameters used
ASCII
'e' OFFSETBUFFER,
EPCID_UID, LEN_ID,
LEN_DATA
'g' OFFSETBUFFER,
EPCID_UID, LEN_ID,
NEW-LEN_ID, PSWD
'j' EPCID_UID, LEN_ID,
PSWD
'y' EPCID_UID, LEN_ID,
PSWD, ACTION, MASK
'z' EPCID_UID, LEN_ID,
MODE
'l' OFFSETBUFFER
'a' --
'x' LEN_DATA, CONFIG
Configuring the instructions
4.6 Programming the Ident profile
Description
Transfers further commands not specified in the
standard profile. To this end, a corresponding
data structure is defined in the send data buffer
for each command.
Writes a new EPC-ID to the transponder.
The transponder is permanently deactivated.
The corresponding memory area of the tran-
sponder is blocked as specified.
The black list is processed. The current tran-
sponder can be added, all identified transpond-
ers added, individual transponders deleted or all
transponders deleted.
The entire TagIDs are read out from the black
list.
Reads out the parameters from the communica-
tions module/reader.
Sends new parameters to the communications
module/reader.
73