Siemens SIMATIC Ident Function Manual page 55

Results
Apply the correct data type that is assigned to the ATTRIBUTE value at the
"IDENT_DATA" input of the instruction so that the data can be correctly interpreted. Only
an Array of Byte can be created at the "Ident Data" parameter . The conversion to the
corresponding data type must be done manually.
Table 4- 34 ATTRIBUTE "0x81" (data type "IID_READSTAT_81_RF2_3_U")
Name
status_info
hardware
hardware_version
loader version
firmware
firmware_version_HB
firmware version LB
driver
driver version
interface
baud
reserved1
reserved2
reserved3
distance_limiting_SLG
multitag SLG
field ON control SLG
field ON time SLG
sync SLG
status_ant
stand by
MDS_control
Table 4- 35 ATTRIBUTE "0x86" (data type "IID_READSTAT_86_RF300")
Name
status info
FZP
ABZ
CFZ
SFZ
CRCFZ
BSTAT
ASMFZ
reserved0
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
Type Comment
SINT Reader status mode
SINT Type of hardware
INT Version of hardware
0 = RF310R, RF340R, RF350R; 1 = RF380R, RF260R; 2
= RF310R (ISO), RF210R, RF220R; 3 = RF380R (ISO),
RF240R; 4 = RF340R (ISO), RF350R (ISO), RF250R; 5
= RF310R (ISO); 8 = MV400/MV500; A = RF310R Gen2,
RF290R; B = RF340R Gen2; C = RF350R Gen2; D =
RF380R Gen2; M = RF280R RS422; N = RF280R RS232
INT Version of loader
SINT Type of firmware
SINT Version of firmware
SINT Version of firmware
SINT Type of driver
INT Version of driver
SINT Type of interface
0x01 = RS422; 0x02 = RS232
SINT Baudrate
0x01 = 19.2 kBd; 0x03 = 57.6 kBd; 0x05 = 115.2
kBd
SINT Reserved
SINT Reserved
SINT Reserved
SINT Distance limiting of Reader
SINT Multitag Reader
SINT Field ON control
SINT Field On time
SINT Synchronization with Reader
SINT Status of antenne
0x01 = on; 0x02 = off
SINT Time of standby after command
SINT Presence mode
Type Comment
SINT Reader status mode
SINT Error counter passive: distortion without commu-
nication
SINT Dropout counter
SINT Code error counter
SINT Signature error counter
SINT CRC-error counter
SINT Status of last command
SINT Error counter for host interface (ASM)
SINT[17] Reserved
Configuring the instructions
4.5 Programming instructions
55