Set_Param - Siemens SIMATIC Ident Function Manual
Hide thumbs
Also See for SIMATIC Ident:
- System manual (362 pages) ,
- Function manual (142 pages) ,
- Operating manual (80 pages)
Table of Contents
Advertisement
4.5.3.8
Set_Param
Using the "Set_Param" instruction, you can change UHF parameters (e.g. the antenna
power) on an RF61xR/RF68xR, as well as the date/time parameters of an
RF18xC/RF18xCI during runtime. Note that changes to the date/time parameters of an
RF18xC/RF18xCI can only be made via the "CM_Configuration" module.
Note
Settings saved only temporarily
Note that the parameters in the "Set_Param" instruction are only stored temporarily. If
the power for the module is interrupted, the stored values are lost and must be set again.
Figure 4-17 Instruction "Set_Param"
Table 4- 29 Explanation for the instruction "Set_Param"
Parameter
PARMID
VALUE
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
Data type
Default values
DINT
0x00
DINT
0x00
Configuring the instructions
4.5 Programming instructions
Description
Parameter identifier
Parameter value
49
Advertisement
Table of Contents
