Unplugging The Header - MacDon R85 Operator's Manual

4.15 Unplugging the Header

Follow these steps to remove plugged material from the header:
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove
the key before removing plugged material from header.
1. Stop forward movement of the windrower and
disengage the header.
2. Raise the header fully.
3. Stop the engine and remove the key.
4. Engage header safety props.
Engaging/Disengaging the Header Safety Props, page
26.
WARNING
Wear heavy gloves when working around cutterbar.
5. Open the cutterbar doors.
Doors, page 30.
6. Clean off the cutterbar or rolls by hand.
NOTE:
Header reversing feature is standard to M205
windrowers.
147757
OPERATING THE HEADER
Refer to
3.3
Refer to
3.5 Cutterbar
97
Figure 4.25: Cutterbar Doors
Revision B