Header Safety Props - MacDon R85 Operator's Manual

5.3 Header Safety Props

Safety props are located on both header lift cylinders on the windrower.
DANGER
To avoid bodily injury from fall of raised header, always engage safety props when working on or around
raised header, and before going under header for any reason.
Engage safety props as follows:
1. Start engine and press HEADER UP (A) switch to raise
header to maximum height.
2. Rephase cylinders if one end of the header does not
raise fully. If rephasing is needed, proceed as follows:
a. Press and hold the HEADER UP (A) switch until
both cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds.
Cylinders are phased.
3. Pull lever (A) and rotate toward header to lower safety
prop (B) onto cylinder. Repeat for opposite cylinder.
169457
OPERATION
Figure 5.2: Ground Speed Lever (GSL)
Figure 5.3: Safety Prop
28
Revision G