Entering Names For The Heating Circuit; Changing The Standard Menu - Viessmann VITOTRONIC 200-H Operating Instructions Manual

Further Adjustments
Entering Names for the Heating Circuits

Changing the Standard Menu

24
Vitotronic 200-H, HK1B Operating
You can give heating circuits 1, 2 and 3 ("HC1", "HC2"
and "HC3") individual names. The abbreviations "HC1",
"HC2" and "HC3" will be retained.
Extended menu
1.
2. "Settings"
3. "Name for heating circ."
4. "Heating circuit 1", "Heating circuit 2 or "Heating
circuit 3"
5. "Change?"
6. You can select the required symbol with
7. takes you to the next character.
8. Press OK to accept all entered characters at once
and simultaneously exit this menu.
Note: The entered term is deleted with "Reset
"Heating circuit 1" will then be shown again.
Example:
Name for "Heating circuit 1":
Ground floor
The menu shows "Ground floor" for "Heating circuit 1".
If your heating system has several heating circuits,
you can select the heating circuit to be displayed
in the standard menu (see chapter "Menu").
Note: If there is only one heating circuit, this menu
is not available.
No heating circuit designation "HC..." is shown
in the header.
Extended menu
1.
2. "Settings"
3. "Standard menu"
4. Select the heating circuit:
H "Heating circuit 1"
Display in the header: "HC1"
H "Heating circuit 2"*
Display in the header: "HC2"
H "Heating circuit 3"*
Display in the header: "HC3"
* Only available with the installation of an accessory
module - extension for heating circuits 2 & 3.
.
?
";