Vitotronic 200-H, HK1B Operating
Commissioning
Your Control Unit is Preset at the Factory
The commissioning and matching of the control unit
to local conditions and building characteristics, as well
as instructing the user in the operation of the system,
must be carried out by your heating contractor.
The control units are factory-set to "Heating and DHW".
Central heating
H Between 06:00 and 22:00 h, the rooms are heated
to 68° F (20° C) "Set room temperature" (standard
heating mode).
H Between 22:00 and 06:00 h, the rooms are heated
to 37.5° F (3° C) "Set red. room temp" (reduced
heating mode, frost protection).
H Your heating contractor can make further settings for
you during commissioning.
You can change any settings individually at any time
to suit your requirements (see chapter "Central heating").
DHW heating
H Only if the DHW tank is connected to the control unit.
Between 05:30 and 22:00 h, DHW is heated to 122° F
(50° C) "Set DHW temperature". A DHW circulation
pump that may be installed is ON.
H Between 22:00 and 05:30 h, the DHW tank
temperature will not be reheated. A DHW circulation
pump that may be installed is OFF.
H Your heating contractor can make further settings
for you during commissioning.
You can change any settings individually at any time
to suit your requirements (see chapter "DHW heating").
Wintertime/summertime changeover
H This changeover is automatic.
Time and date
H The day and time were set by your heating contractor
during commissioning.
Power failure
H All data is saved if there is a power failure.
Terminology
To provide you with a better understanding of the
functions of your control unit, the appendix contains
the chapter "Terminology" (see page 34).
General
5