Setting The Heating Program For Central Heating; Setting The Time Program For Central Heating - Viessmann VITOTRONIC 200-H Operating Instructions Manual

Vitotronic 200-H, HK1B Operating

Setting the Heating Program for Central Heating

Setting the Time Program for Central Heating

Factory setting: "Heating and DHW"
For the heating circuit displayed in the header
Proceed as described on page 12.
For the other heating circuits
Extended menu
1.
2. "Heating"
3. Select the heating circuit, if necessary (see page 13).
4. "Heating program"
5. "Heating and DHW"
H The rooms of the selected heating circuit are heated
in accordance with the room temperature and time
program settings.
H DHW is reheated in accordance with the set DHW
temperature and time program (see chapter "DHW
heating").
H The time program for central heating is made up of time
phases. One time phase from 6:00 to 22:00 h for every
day of the week is set at the factory.
H You can set the time program individually, to be
the same for every day of the week or different:
You can select up to 4 time phases per day for standard
heating mode. Set the start and end points for each
time phase. Between these time phases, the rooms
are heated with the reduced room temperature (see
chapter "Setting the room temperature for reduced
heating mode").
H When setting, bear in mind that your heating system
requires some time to heat the rooms to the required
temperature.
H In the extended menu, you can scan the current time
program under "Information" (see chapter "Scanning
information", "Heating circuit ..." group).
Extended menu:
1.
2. "Heating"
3. Select the heating circuit if necessary.
4. "Heating time program"
5. Select part of the week or a day.
6. Select the time phase !, ?, § or $.
7. Set the start and end points for the relevant time
phase.
8. Press to exit the menu.
Note: If you want to terminate a time phase setting
process prematurely, keep pressing
required display appears.
Central Heating
until the
15