Configuring Passwords - Comtrol DeviceMaster AIR User Manual

Configuring Passwords

Configuring Passwords
54 - DeviceMaster AIR User Guide: 2000365 Rev. C
If uploading SocketServer:
a. At the RedBoot> prompt, type: fis list and press Enter.
RedBoot> fis list
Name
FIS_directory 0x053F0000
default
RedBoot>
Note: You should see file information for a file called default. If you do not
see this file, repeat the process starting with
b. Reset the DeviceMaster AIR by typing reset at the RedBoot> prompt.
Note: In a few seconds the ethernet and PWR LEDs cycle through a light
sequence once.
c. Start your internet browser and enter the IP address of the DeviceMaster
AIR to verify that the new version of SocketServer loads.
Note: Your SocketServer version may be different. The default IP address is:
192.168.250.250.
If it displays an NS-Link version, you must update the driver to update the
SocketServer. If you want to only run the ports in socket mode (not COM
mode), you can remove the NS-Link driver.
This section discusses how to configure a password for the web and telnet server.
Note: See the PortVision Plus or SocketServer help system for information about
email notification.
Use the following procedure to establish the DeviceMaster AIR password for the
Web and telnet server. Establishing a password prevents unauthorized changes to
the DeviceMaster AIR configuration.
1. Establish communications with the DeviceMaster AIR using the serial (Page
51) or telnet method (Page 48).
2. Type password [your_password] and press Enter.
Note: If you forget your password, you can reprogram the password using the
serial method which bypasses the password.
Password:
Comtrol DeviceMaster Boot Version 1.20
RedBoot(tm) debug environment - built 14:57:53, Jun 21 2004
Platform: Comtrol DeviceMaster (ARM 7TDMI)
Portions Copyright (C) 2000. Red Hat, Inc.
Portions Copyright (C) 2001-2004. Comtrol Corp.
RedBoot> dis
Loading disabled
RedBoot> password dev1357
Password 'dev1357'
RedBoot>
Note: The bootloader version on your DeviceMaster AIR may be different than
the version displayed in this graphic.
See the auth command in the
to set up Web browser authentication.
FLASH addr Mem addr
0x053F0000
0x05030000 0x00000000
Redboot Command Overview
Length Entry point
0x00010000 0x00000000
0x00090000 0x00000000
Step 7.
on Page 55 if you want
RedBoot Procedures