Table of Contents
Advertisement
Adjusting the valve clearance
Fig. 67
Final work
Fig. 68
Fig. 69
8.9.3 Changing the engine oil and cleaning the oil filter
Maintenance – Annually / every 250 operating hours
1.
Loosen screw (3) on the rocker arm.
2.
Adjust the hexagon nut (2), until the feeler gauge (1) can be
inserted and pulled out with noticeable resistance after the
screw (3) has been tightened.
1.
Install the valve cover (2) with a new gasket.
2.
Tighten the fastening screws (1) evenly.
3.
Assemble covering (1) and air filter cover (2).
4.
After a short test run check the valve cover for leaks.
NOTICE!
Danger of engine damage!
–
Change the oil only with the engine at oper-
ating temperature.
–
Use only oil of the permitted specification
Ä Chapter 8.3.1 „Engine oil" on page 65.
–
Filling quantity:
lubricants" on page 68
DRP40DX
Ä Chapter 8.4 „List of fuels and
79
Advertisement
Table of Contents
