Table of Contents
Advertisement
Maintenance – As required
8.11.4
Checking the oil level in the exciter housing
1
Fig. 109
8.11.5
Measures prior to extended shut-down period
8.11.5.1
Measures before shutting down
94
Protective equipment:
1.
Park the machine on level ground.
2.
Park the machine safely
in secured condition" on page 55.
3.
Allow the machine to cool down.
4.
Clean the area around the bleeding screw (1) and filling/drain
plug (2).
5.
Unscrew the bleeding screw.
2
6.
Unscrew the filling/drain plug and check the oil level; top up if
necessary.
ð Nominal value: Bottom edge of filling/drain bore.
7.
Clean the bleed screw and filling/drain plug and screw them
in with a low-strength sealing agent (e.g. spare parts number:
DL 009 700 16).
B-692-0015
If the machine is shut down for a longer period of time, e.g. winter
season, the following work must be carried out:
1.
Clean the machine thoroughly.
2.
Clean the water separator.
3.
Fill the fuel tank with diesel fuel, to prevent the formation of
condensation water in the tank.
4.
Change engine oil and oil filter if the oil change had been car-
ried out more than 300 operating hours ago.
5.
Change the fuel filter.
6.
After shutting down store the machine under cover in a dry
and well ventilated room.
7.
Protect the cooled down engine against dust and moisture.
NOTICE!
Components may get damaged!
–
Use only oil of the permitted specification
Ä Chapter 8.4 „List of fuels and lubri-
cants" on page 68.
–
Do not use low-ash engine oils for the exciter
shaft housing.
n
Working clothes
Safety shoes
n
Protective gloves
n
DRP40DX
Ä Chapter 6.4 „Parking the machine
Advertisement
Table of Contents
