Table of Contents
Advertisement
WARNING: BEFORE PERFORMING ANY REPAIR, MAINTENANCE, OR
ASSEMBLY, MAKE SURE THE THROWING ARM IS IN THE UNCOCKED
POSITION (SEE BELOW), THE ON/OFF/SAFE RELEASE SWITCH LOCATED
ON THE REAR OF THE TRAP IS IN THE 'OFF' POSITION (SEE BELOW), THE
BATTERY IS DISCONNECTED FROM THE TRAP, AND THE MAINSPRING IS
DISENGAGED.
(Following completion of assembly) If the throwing arm is in the cocked arm position (see
photo below), un-cock the throwing arm by first connecting the red battery lead to the positive (+)
terminal and the black battery lead to the negative (-) terminal on the battery. Place one clay on the
throwing arm, momentarily press the on/off/safe release switch to the "SAFE RELEASE" position to release
the throwing arm while standing in a safe position. After the trap fires, release the ON/OFF/SAFE
RELEASE switch to return to the "OFF" position. The throwing arm should now be in the safe release
position. Disconnect the battery from the trap.
2.0"- 4.0"
Cocked Arm Position
(Ready to Launch
Target)
Circuit Breaker
WARNING: FAILURE TO FOLLOW SAFETY RULES CAN
RESULT IN SERIOUS INJURY OR DEATH!
4.5"
ON/OFF/SAFE RELEASE Switch
(Shown in OFF Position)
6
Un-cocked Arm
Position (Ready to
Load Targets)
Advertisement
Table of Contents
