Table of Contents
Advertisement
Setup
(E)
WARNING: MAKE SURE THAT THE "ON-OFF-SAFE RELEASE" SWITCH IS SET TO THE "OFF"
POSITION BEFORE CONNECTING POWER TO THE TRAP. AN UNINTENTIONAL DISCHARGE OF
THE TRAP COULD CAUSE SERIOUS INJURY OR DEATH.
DO NOT OPERATE THE TRAP IN AN AREA THAT DOES NOT ALLOW SAFE (REAR) ACCESS TO
THE TRAP AND THE ON/OFF/SAFE RELEASE SWITCH DURING LOADING AND USE.
b. Remove the Arm Retention Pin (SP1) from the top plate and put it in the rear storage hole.
(If you have forgotten to remove the retention pin and the throwing arm is wedged
against the retention pin, release the tension on the mainspring. DO NOT lift the
retention pin with force. If the arm is stuck, the throwing arm will immediately cycle
and cause injury or damage to the trap.)
c. Remove wire ties from foot pedal release cable and attach plug end to plug on the
trap. Place foot pedal switch on firm ground.
Arm Retention Pin
2.
For additional stability of the trap, the ground stake can be placed through the rear hole of C2
(Handle Support Bracket) and driven into the ground.
3.
Connecting the red battery leads to the positive (+) terminal and the black battery leading to the
negative (-) terminal of a charged deep cycle 12V Battery.
4.
Before loading targets into the trap, turn the On/Off/Safe Release switch to the "ON" position and
check the function of the trap by depressing the foot pedal. If the trap does not function correctly,
see section "VI. ADJUSTMENTS" on page 43.
Note: It is acceptable to dry fire the trap (fire the trap without launching a target).
This will not damage the trap.
5.
Disconnect the battery leads from the battery.
Rear Storage hole
41
SP1
Advertisement
Table of Contents
