Table of Contents
Advertisement
90mm Midi Conversion Assembly
(D)
FOLLOW THESE STEPS TO CONVERT THE TRAP TO THROW 90MM MIDI CLAYS INSTEAD OF 110MM STANDARD
CLAYS.
Midi Parts Needed
MA1- Midi adaptor
MA2- Slide plate Midi adaptor
MA3- M5-.8 x 9.5mm button head screw (3)
MA4- 10mm washer (3)
Tools Needed
#2 Phillips screwdriver
7MM Wrench
2.5MM Allen Wrench
1. Attaching the Magazine Studs
A. Remove the nut from the Magazine Stud (MA5) using a 7mm wrench and a 2.5mm Allen wrench, and then
remove the bolt. See figure 25.
B. Insert and tighten the magazine stud bolt through the Midi adapter's bottom with Magazine Studs (MA1) hole,
as shown in figure 26. Repeat for the opposite bolt. Use a 7mm wrench and a 2.5mm Allen wrench.
i. Make sure the shelf on the stud MA5 is on the bottom.
Figure 25
MA1
MA5
Figure 26
36
M1
M5
M2
M3
M4
Figure 27
Advertisement
Table of Contents
