Champion Freedom Bird Instruction Manual page 59

Troubleshooting
WARNING: MAKE SURE THAT THE THROWING ARM IS IN THE UNCOCKED POSITION AND THE
TRAP IS IN THE OFF POSITION BEFORE MAKING ANY ADJUSTMENTS TO THE RECEIVER.
WARNING: DO NOT MANUALLY FORCE THE THROWING ARM THROUGH THE UNCOCKED
POSITION AS THE MAINSPRING WILL TAKE OVER AND FIRE THE TRAP, POTENTIALLY CAUSING
SERIOUS INJURY OR DEATH.
The Wireless Remote Transmitter Signal Light (H) is Flashing
1. Replace the Battery in the Wireless Remote Transmitter.
The Wireless Remote Transmitter Does Not Operate the Receiver
Check that the Receiver Status light (C) is on and green.
1.
Check that the Signal Light (H) on the Wireless Remote Transmitter turns red when
2.
depressing the Throw Button (G).
Reprogram the Wireless Remote Transmitter to the receiver (see Programming).
3.
Check battery orientation or replace the battery in the Wireless Remote Transmitter.
4.
Reduced Operating Range
1. Replace the Battery in the Wireless Remote Transmitter with a new A23 battery.
The wireless remote system uses radio-based communication between the remote and the
receiver. As in all radio-based communication, performance will vary based on the environment
and configuration of the system.
If the Transmitter fails to trigger the receiver, the following steps may help improve operation:
Move the Wireless Remote Transmitter closer to the receiver. This will also help to confirm that
•
the Wireless Remote Transmitter and Receiver are programmed and functioning properly.
Press the Throw Button (G) on the Wireless Remote Transmitter for one to two seconds.
•
Hold the Wireless Remote Transmitter with antenna vertical (pointed upwards to the sky).
•
Do not point the antenna at the receiver.
Hold the Wireless Remote Transmitter higher.
•
Make sure there is no structure between the Wireless Remote Transmitter and the receiver.
•
Move the receiver to an elevated position to place the antenna at a greater height.
•
59