Table of Contents
Advertisement
Installation
WARNING: MAKE SURE THAT THE THROWING ARM IS IN THE UNCOCKED POSITION, THE TRAP IS IN THE
OFF POSITION, THE MAINSPRING IS REMOVED, AND THE TRAP IS DISCONNECTED FROM THE BATTERY.
THE FOOT PEDAL MUST BE REMOVED FROM THE TRAP BEFORE USING A REMOTE
TRANSMITTER/RECEIVER TO ACTIVATE THE TRAP.
WARNING: DO NOT MANUALLY FORCE THE THROWING ARM THROUGH THE UNCOCKED POSITION
AS THE MAINSPRINGNG WILL TAKE OVER AND FIRE THE TRAP, POTENTIALLY CAUSING SERIOUS
INJURY OR DEATH.
Mounting the Receiver
Perform a safe release, turn the power off, disconnect the battery, and empty the trap magazine.
1.
Screw the receiver's 12V Power and Output Connector male plug (F) onto the female 12V
2.
Power and Output Connector. The receiver should be mounted to the back of the, with
top of the Receiver flush with trap, using the receiver hooks on the trap.
Programming (Pairing Receiver and the Transmitter)
Before operating, the receiver(s) (see note below regarding controlling multiple Receivers) will need to be
programmed to respond to the Wireless Remote Transmitter you will be using.
Install a 12V A23 Battery in the Wire Receiver Transmitter.
1.
The receiver should be mounted and installed per "Installation" directions above.
2.
Connect trap to the battery and turn trap to "ON" (Trap must be turned "ON" to provide power
3.
to the receiver). This will arm the trap, and the throwing arm will move into the cocked position.
The Receiver Status Light (C) on the Receiver will be green, indicating it is powered "ON" and
will accept a signal from the Wireless Remote Transmitter. Press the Remote Learn Button (A) to
enter the learning mode. Remote Learn Light (B) will slowly flash to indicate the receiver is
ready to learn the Wireless Remote Transmitter's signal. Next, quickly press the Throw Button (G)
on the Wireless Remote Transmitter Receiver to learn the signal. Once the receiver has learned
the signal, the Remote Learn Light (B) will flash rapidly three times, confirming the receiver has
been programmed to the Wireless Remote Transmitter.
Verify the Wireless Remote Transmitter and Receiver are programmed by setting Throw Delay
4.
(E) to 0 seconds and press Throw Button (G). If Programming were successful, the trap would fir
if therapy does not fire when Throw Button (G) is pressed perform programming process
again or set troubleshooting section on next page.
Perform safe release on trap and disconnect trap from 12V Battery.
5.
NOTE: Multiple receivers can be assigned to one (1) transmitter. This will allow multiple traps to be controlled
simultaneously from one remote. Use the Throw Delay knob (E) on each receiver to set the desired delay time
(0-15 sec) between traps.
WARNING: BEFORE PAIRING THE TRANSMITTER TO A NEW RECEIVER, ENSURE THAT THE BATTERY IS
DISCONNECTED ON ALL TRAPS USED WITH ANY PREVIOUSLY PAIRED RECEIVER.
56
Advertisement
Table of Contents
