Table of Contents
Advertisement
Limit Switch
Adjustments to the limit switch are made by loosening the two mounting screws and moving the switch
slightly (small movements will make a big difference):
1.
Pivot the switch slightly towards the rear of the trap to make the arm stop further away from the
edge of the main body.
2.
Pivot the switch slightly towards the front of the trap to make the arms stop closer to the edge of
the main body.
3.
Retighten the mounting screws after adjusting the switch.
4.
Adjust switch so that a target drops onto the throwing arm as the arm is cocking. With the
ON/OFF/SAFE RELEASE switch set to "on," the tip of the arm should stop within 2.0" to 4.0" from the
edge of the top plate of the trap. The opening in the sliding plate should line up with the
opening in the top plate and allow a target to drop.
WARNING: ADJUSTING THE ARM TO STOP AT A POINT TOO FAR AWAY FROM THE
TRAP BODY CAN RESULT IN A DELAYED-RELEASE OR IMPROPER LOADING AND
TARGET BRAKING, WHICH COULD RESULT IN PERSONAL INJURY OR DEATH
FROM THE THROWING ARM.
WARNING: ADJUSTING THE ARM TO STOP AT A POINT TOO CLOSE TO THE
TRAP BODY CAN RESULT IN THE ARM CONTINUOUSLY FIRING OR FIRING
UNEXPECTEDLY, WHICH COULD RESULT IN PERSONAL INJURY OR DEATH
FROM THE THROWING ARM.
2" - 4"
44
Advertisement
Table of Contents
