Table of Contents
Advertisement
(A)
Throwing Arm Limit Switch
WARNING: BEFORE MAKING ANY ADJUSTMENTS MAKE SURE THE THROWING
ARM IS IN THE UNCOCKED POSITION, THE ON/OFF/SAFE RELEASE SWITCH IS
IN THE "OFF" POSITION, AND THE BATTERY IS DISCONNECTED FROM THE
TRAP! DO NOT MANUALLY FORCE THE THROWING ARM THROUGH THE
UNCOCKED POSITION AS THE MAINSPRING WILL TAKE OVER AND FIRE THE
TRAP, POTENTIALLY CAUSING SERIOUS INJURY OR DEATH.
The machine is set at the factory. Only adjust the limit switch if a target doesn't drop onto the
throwing arm as the throwing arm is cocking, or the throwing arm continuously fires. TEST
MACHINE FIRST WITHOUT ANY TARGETS.
*If you "Dry Fire" test with the wireless remote, the throwing arm could cycle twice. The receiver is
electronically programmed to weigh the clay on the throwing arm. *
The limit switch controls the stop position of the throwing arm during the trap cocking cycle. The limit
switch is located under the trap near the front. The front cover can be removed to gain easier access
to the switch. Replace cover after adjusting switch.
VI. Adjustments
43
Advertisement
Table of Contents
