Table of Contents
Advertisement
Operation
Set Mainspring on the trap.
1.
Connect trap to 12V Battery
2.
Set trap main power switch to "ON." Receiver Status Light (C) will light up green to indicate
3.
the receiver is activated and ready to receive signals from the Transmitter.
Repeat above steps 1- 3 for additional traps/receivers if operating multiple traps
4.
from the Transmitter.
Operate trap (s) by pushing Throw Button (G) on Wireless Remote Transmitter to launch target
5.
from the trap (s). The Wireless Remote Transmitter will now function each time you press the
Throw button (G). Thus, each push of the Throw Button (G) will launch every active trap within
range. Note: If Throw Button (G) is pressed while a Receiver has a Throw Delay time set, it will only fire
once within the delay interval.
To disarm the receiver (s) and safely stop trap (s) operation:
1. Perform safe release on trap and disconnect trap from 12V Battery.
To reinstall foot pedal if desired:
Disconnect the receiver's 12V Power and Output connector (F) from the trap.
1.
Remove receiver from the trap and attach the foot pedal to12V Power and Output connector on
2.
the trap.
58
Advertisement
Table of Contents
