Bcr Location (Scanner Position); Job Id; Set Integrity; Select Feed - Pitney Bowes F65A Operator's Manual

BCR location (scanner position)

Here you select the scanner position, all available positions are defined in the Service
menu here you can only select already defined positions.
001> BCR Location: TOP-REAR
<>=SELECT Green=CONF. Blue=EXIT Red=GO ON
We select "TOP-REAR" in our example.

Job id

The maximum is defined as 31 characters. You can set a number between 0 and 31 for
this definition.
001> Job ID (0-31): 2
<>=SELECT Green=CONF. Blue=EXIT Red=GO ON

Set integrity

The maximum is defined as nine characters. You can set a number between 0 and 9 for
this definition.
0001> SI (0-9): 2
<>=SELECT Green=CONF. Blue=EXIT Red=GO ON
We select "2" in our example.

Select feed

Depending on your job there is the possibility to add after the feeder material from the se-
lect feed tower. This Information will be sent to the MF 4000.
001> Select feed (1-5): NO
<>=SELECT Green=CONF. Blue=EXIT Red=GO ON
We select "NO" in our example.
001> Select feed (6-10): NO
<>=SELECT Green=CONF. Blue=EXIT Red=GO ON
For the next group 6-10 we select as well "No"

Optional functions

This is not in use in the current SW but is available as custom SW.

Bypass advanced settings

There are two settings available.
• Set Integrity Random
• Page counter direction: (count up or count down)
001> Bypass advanced settings
Green=YES Blue=EXIT
We select "YES" in our example.
(YES means SI (Set Integrity does not follow a pattern)
Red=NO
31