Table of Contents
Advertisement
3.
Knurled nuts alignement - Turn both knurled nuts
so that they are flush with the end of the threaded
rod.
4.
Careful placement - The long edge of the sensor
must be placed onto the surface to be measured
and then tilted. The magnets pull the sensor onto
the surface.
5.
Placement validation - If the magnets do not auto-
matically jump onto the measuring surface, press
down the knurled nuts one after the other. The
magnets should now jump onto the surface. The
attraction force of the magnets is now optimal.
- The sensor shall not be moved onces placed on the surface�
- The magnets have ground guides� Make sure that both sides
of the guide rest on the surface!
Subject to technical modifications
11 / 56
Advertisement
Table of Contents
