Table of Contents
Advertisement
• The maximum tension applied on the tie bar's surface
is located below the Max� Tension title. This value
can be displayed in the strain unit "με" (micro strain)
as well as in the force units "kN" (kilo Newton), "t"
(tons), "tUS" (US tons), "tUK" (UK tons)*.
• The bending direction is given as an angle measured
from the most-right sensor.This angle is called Ө, and
is indicated with a blue arrow.
• Different commands can be executed through the
displayed buttons.
* to calculate force units, the diameter of the Tie Bars must be set in the Settings
The maximum tension and the direction of the bending are
only valid at the longitudinal position of the tie bar in which
the 4 sensors are placed�
Subject to technical modifications
A snapshot of the measured
save_alt
data is saved in a CSV file
Checks the proper mount-
ing of the sensors
Opens the unit selection
popup
Resets the sensors signal
RESET
to zero (Tare)
settings
page.
35 / 56
Advertisement
Table of Contents
