Table of Contents
Advertisement
5�2�
Adding a QE2008-W sensor to a network
Folow these steps to add an unassigned QE2008-W sensor to an existing QE2008-W network.
In the following example, an unassigned sensor is added to the network with ID 42CA000531 at position 1�1.
1.
If the Sensormate app has an active connection,
disconnect.
2.
Turn on the unassigned sensor to be added to a
network.
3.
Turn on at least one of the QE2008-W sensors that
belongs to the target network.
4.
On the Device List page, scan for BLE devices.
A "QE2008-W Set" item corresponding to the target
network will appear in the device list.
5.
Once the scan is over, a pop-up message will notify
that an unassigned device was found. Select the
option "Show existing networks".
6.
In the Devices list, locate the destination network
item and press Connect.
7.
A prompt will ask if it is wanted to add an unassi-
gned device to the current network. Select Yes.
Subject to technical modifications
47 / 56
Advertisement
Table of Contents
