Table of Contents
Advertisement
6.
While the mounting viewer is open, the function
LEDs of the selected sensors will indicate their
relative alignment status. LEDs are
the sensors are not correctly aligned and they are
GREEN
when they are correctly aligned.
In case of incorrect alignment, unmount the most
accessible sensor and, hovering it around the tie
bar, find the position where the LEDs become
GREEN. This indicates the correct angular position
(180°) where to mount the sensor.
7.
Mount the sensor at the previosly found position.
Check that the LEDs are
ting. If they are not, repeat this step until you find
the correct spot.
7.
Repeat for all the Tie Bars that show an exclamati-
on mark
RED
when
GREEN
after the moun-
Always tilt the sensors and place
them from the long edge when
mounting
Never drag the sensors through
the surface when the magnets
are pulling� This can cause dama-
ge to the sensing element�
Subject to technical modifications
19 / 56
Advertisement
Table of Contents
