gefran SENSORMATE QE2008-W SET User Manual page 27

4�1�2�1� Mounting - 4 Sensors on the Tie Bar
Please refer to "2�1� Sensor Handling and Installation" on page 10 for instructions on how to install the
QE2008-W sensors on any ferromagnetic surface.
For this measurement, 4 sensors must be placed on a single tie bar. The sensors must be evenly distributed around
the tie bar, 90° apart from each other, and their external edges should be aligned.
Procedure
• Choose 4 QE2008-W sensors
• Select one of the 4 tie bars of the machine to mount the chosen sensors on.
• Mount one sensor on the tie bar, placing it away from
the clamping platen at least at a distance equal to the
tie bar diameter. This placement assures an even and
correct measurement of the deformation of the tie bar.
Given that 4 sensors will be mounted on the same tie bar, it is strongly advised to mount the
first sensor on the least accessible position of the tie bar. The rest of the sensors positions
will be referenced to this sensor.
• Take the second sensor and mount it on the same tie
bar at 180° from the first, keeping it on the same axis
(external edges aligned).
Subject to technical modifications
27 / 56