Scan For Qe2008-W Networks; Qe2008-W Connection - gefran SENSORMATE QE2008-W SET User Manual

3�2�

Scan for QE2008-W Networks

• When the Sensormate app is started, the device list page is presented.
• A "scan for devices" is automatically launched for approximately 15s. If during this interval no QE2008-W net-
works/devices were found, please make sure they are turned on and launch manually the "scan for devices".
When a device has been found, it is added to the device list and becomes available for connection.
• When connecting to a device, the navigation menu opens.
menu
Tapping the icon also opens the navigation menu. To close it, tap anywhere outside the menu.
• The navigation menu shows the pages available for the connected device. From these pages the user can config-
ure and control the device, as well as process, analyse and store measurements.
3�3�

QE2008-W connection

• After having scanned (refer to previous paragraph) and found the desired QE2008-W sensors, the connection
between the sensors and the app can be established. The discovered QE2008-W sensors will be added under the
"QE2008-W Set" item in device list page.
Network unique identifier
• Tap connect in order to establish a connection with the QE2008-W Set.
• Wait until the status of the network is "online". The set is now ready to be used.
14 / 56
Network
devices
- Bluetooth must be enabled for the Sensormate app to disco-
ver nearby devices
Subject to technical modifications
Set discovered devices
Network
status