Table of Contents
Advertisement
APPENDIX E - REPACKING FOR SHIPMENT
E-1
SHIPPING INFORMATION
IFR test sets returned to factory for calibration, service or repair
must be repackaged and shipped subject to the following conditions:
Do not return any products to factory without first receiving
authorization from IFR Customer Service Department.
CONTACT:
Customer Service Dept.
IFR, Inc.
10200 West York Street
Wichita, Kansas
67215
Telephone:
(800)-835-2350
TWX:
910-741-6952
All test sets must be tagged with:
a.
Owner's identification and address.
b.
Nature of service or repair required.
c.
Model No.
d.
Serial No.
Sets must be repackaged in original shipping containers using IFR
packing models.
If original shipping containers and materials
are not available, contact IFR Customer Service Dept. for
shipping instructions.
All freight costs on non-warranty shipments are assumed by
customer.
(See ''Warranty Packet'' for freight charge policy on
w arran ty c 1 aims. )
E-2
REPACKING PROCEDURE (REFERENCE - FIGURE E-1)
1.
Make sure bottom packing mold is seated on floor of shipping
container.
2.
Carefully wrap test set with polyethylene sheeting to protect
finish.
3.
Place test set into shipping container, making sure set is
securely seated in bottom packing mold.
4.
Place top packing mold over top of set and press down until
mold rests solidly on bottom packing mold.
5.
Close shipping container lids and seal with shipping tape or
an industrial stapler.
Tie all sides of container with break-
resistant rope, twine or equivalent.
E-1
Advertisement
Table of Contents
