Gpib Operation - Option 13; General; Preparation For Using Gpib - IFR FM/AM-1200A Operation Manual

5-12 GPIB OPERATION - OPTION 13
5-12-1 GENERAL
This section contains basic instructions for operating the FM/AM-
1200S/A with the optional General Purpose Interface Buss (GPIB) com-
patible external device. Using these instructions, the operator can
select any available parameter of the following FM/AM-1200S/A functions:
DTMF OFFSET IMTS (PULSE) METER
TONE RF TONE WAVEFORM DCS MODULATION
5-12-2 PREPARATION FOR USING GPIB
When the GPIB option is installed, a 24-pin GPIB connector is provided
on the rear panel in place of the standard RS-232 connector. Pinouts
for the GPIB connector are shown in Appendix B, Table B-4. The
operator should insure proper interface between the FM/AM-1200S/A and
the external controller. Once the proper connection is made, the FM/AM-
1200S/A can be initialized with the proper address by using the GPIB
Menu.
5-12-3 FM/AM-1200S/A INITIALIZATION
Use the following procedure to initialize the FM/AM-1200S/A for GPIB
~.
operation:
STEP PROCEDURE
1. Connect the external controller to the FM/AM-1200S/A at the GPIB
Connector.
2.
3.
Press: : - ~~~on the Keyboard (18).
Using the scroll keys and numbers, select:
9600 BAUD RATE (Selection 6)
NO PARITY ( 0
=
NONE, 1
=
ODD, 2
=
EVEN)
8 DATA Bits
( 7
or 8)
1 STOP Bit (1 or 2)
GPIB ADDRESS (00 thru
3 1 )
5-21
05